Using the manual lumbar support Turn the lumbar support control toward the front of vehicle to move the lumbar support forward for more direct support. Rewind The rewind control works in tape mode. Fuel vapor is extremely hazardous under certain conditions. The bars of varying length are for intermittent wipers. A danger lies in losing traction, slipping sideways and possibly rolling over.
Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Stop the vehicle as soon as safely possible, turn off the engine. A chime will also sound to remind you to fasten your safety belt. Illuminates when 4H is selected. The more you know and understand about your vehicle the greater the safety and pleasure you will derive from driving it. To raise the height of the shoulder belt, slide the height adjuster up. Report the fault to a dealer at the earliest opportunity.
When fail-safe mode is activated You have limited engine power when in the fail-safe mode, so drive the vehicle with caution. Speaker fade adjust Speaker sound can be adjusted between the front and rear speakers. Clutch fluid reservoir manual transmission 5. Connect the new foglamp bulb to the electrical connector. They can slide around and increase the likelihood of injury or death in a collision. Refer to Programming spare keys for instructions on how to program the coded key.
Ford Motor Company will repair or. Refer to the Folding Down The Rear Seats section in this chapter for information on how to operate the rear seats. This lighting feature is operable when the headlamps are illuminated. Refer to the Installing child safety seats in combination lap and shoulder belt seating positions section of this chapter for further instructions to secure the. Connect the other end of the positive + cable to the positive + terminal of the assisting battery. Do not hold for longer that 30 seconds.
They lift the child up so that the lap belt rests low across the hips and the knees bend comfortably. Always remember to turn on your headlamps at dusk or during inclement weather. Inspect these components carefully periodically during, and after any towing operation. Additional equipment such as snowplow equipment may effect the performance of the air bag sensors increasing the risk of injury. F150 SuperCrew Owners: Snowplowing Your vehicle is not recommended for snowplowing.
Always set the parking brake fully and turn off the ignition when leaving the vehicle. Since this information is subject to. The indicator light will flash green twice. Pull seatback toward front seat and down into load floor position. When changing the air filter element, use only the Motorcraft air filter element listed.
If the safety seat is not anchored properly, the risk of a child being injured in a collision greatly increases. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. Return to the center position to lock mirrors in place. Power steering fluid reservoir 2. Do not install a snowplow and plow with your vehicle until it has been driven at least 800 km 500 miles. .
Turn the blade at an angle from the wiper arm. When in this position rotate the control upward for fast intervals and downward for slow intervals. Four wheel drive low if equipped Illuminates when four-wheel drive low is is engaged. Close the hood and turn off the lamps. Programming your own personal entry code To program your own code: 1. Speed sensitive volume if equipped With this feature, radio volume automatically changes slightly with vehicle speed to compensate for road and wind noise. The reading lamps can be turned on by pressing the rocker controls next to each lamp.