Remove the oil level gauge pipe. View and download mazda cx 7 2007 workshop manual online 2007 mazda cx 7 cx 7 2007 automobile pdf manual download. Before servicing the vehicle, refer to the precautions section. Install the remaining components in the reverse order of removal. Remove the exhaust manifold and gasket.
Support the engine using an engine jack and attachment. Remove the manifold upper and lower insulator. Tighten the camshaft caps using several passes to 71-106 inch lbs. Install the tools illustrated onto the to the extension housing. Install and tighten bolt A to 63-85 ft. Place the sensor in water with a thermometer and heat the water gradually.
Install the oil pump and tighten the bolts in two steps in the sequence illustrated. Remove the air hose by moving the purge solenoid valve slightly out of the way. If equipped with an automatic transmission, disconnect the manual shaft lever component as follows: A. After adjust the camshaft endplay using the thrust caps 1R and 5R, tighten the remaining caps. Make sure to install the cover within 10 minutes of applying the sealant. Disconnect the left hand front drive shaft from the transaxle side. Install the tools illustrated to the crankshaft pulley, lock the crankshaft against rotation.
Remove the windshield wiper arm. Remove the left front mud guard and resonance chamber. The Mazda 6 has been one of the most popular automobiles ever produced by Mazda. Tighten the manifold bolts in the sequence illustrated to 72-106 inch lbs. Before servicing the vehicle, refer to the precautions section. Temporarily tighten the nuts 1, 2, 3 in the order shown in the illustration.
Installation is the reverse of removal. Remove the engine jack and attachment. If the voltage from the fuel temperature sensor is less than 0. Page 61 Back to Top Fig. Remove the cylinder block lower blind plug.
Upper, spacer and lower oil ring identification and positioning-Mazda engines Page 63 Back to Top Fig. When installing the right hand camshaft place the crankshaft keyway at the 3 O-clock position-Mazda6 with the 3. Cylinder head bolt tightening sequence-Mazda6 and Mazdaspeed6 with the 2. Once all the bolts have been removed, remove the cylinder head and gasket. Do not loosen any of the other cap bolts until the thrust caps are removed or you could damage the thrust caps.
Tighten the cylinder head bolts in the sequence illustrated using 5 passes as follows: A. Remove the bolts A, B and C. Acrobat Reader, Foxit, or comparable reader, to be able to open. All worn or damaged drive belts should be replaced immediately. Remove the oil pump bolts and pump.
Thread the sensor into the intake manifold, or thermostat housing, by hand, then tighten it securely. Properly relieve the fuel system pressure. Remove the ignition coils, spark plugs, valve cover and accessory drive belt. Remove the cylinder block lower blind plug. Please note the following special steps: A. The sedan was unveiled at the Moscow International Automobile Salon while the hatchback was presented at the Paris Motor Show. Location of alternator mounting bolts A, B and C-Mazda6 and Mazdaspeed6 models with 2.