Always signal when preparing to stop, turn or pass. The level should be between the A and F marks. The touchscreen has a replaceable screen protector which m remain on the screen. Run motorcycle until engine is at normal operating temperature. Remove the four screws securing the TourPak bracket to the support. Front brake hand lever 2.
. Throttle is rolled off or closed, actuating rolloff disengage switch. Fuel Gauge The fuel gauge indicates the approximate amount of fuel in the fuel tank. Front turn signal lamps also function as running lamps on some vehicles. Clearing message before starting motorcycle : Place transmission in neutral or raise jiffy stand.
Firmly seat the bottom of the windshield bracket to engage the lower grommets 2. Electrical system lamp security system 6. Box Infotainment System Set volume levels and other controls on audio and electronic devices before riding. The first turn signal cancels and opposite turn signal lamps begin flashing. Models with heated hand grips have a variable heat control dial located on the end of the hand grip. For other possible coolant system issues, see Cooling System: TwinCooled Models. Do not use racing fuel or fuel containing methanol.
The shift lever changes gears in a sequential sixspeed transmission. The rear brake pedal controls the rear wheel brake and is located on the motorcycle's right side. If coolant level is sufficient and the lamp remains on, stop the engine immediately and see a HarleyDavidson dealer for service. Touchscreen: Some systems have a touchscreen. For proper windshield maintenance, see Windshield Care.
HarleyDavidson front and rear tires are not the same. Gasoline is extremely flammable and highly explosive, which could result in. Gear Shift Lever Location See Gear Shift Lever and Shift Pattern. The lamps also cancel if the turn signal has been activated for a prolonged period while riding. To Lock Fork on Other Models 1. Engine start switch Hand Controls Heated Hand Grips See Heated Hand Grips. Unskilled or improper use could result in loss of control, death or serious injury.
Pushbutton fuel door: See Push button Fuel Door. Poor visibility of rider to other motorists can result in death or serious injury. Check for coolant leaks on applicable vehicles. These forces may influence the handling characteristics of your motorcycle. Locking fuel door: See Locking Fuel Door. Use of certain other manufacturer's performance parts may void your new motorcycle warranty, except where prohibited by law.
Accessories that change the operator's riding position may increase reaction time and affect handling of the motorcycle. Replace leaking, damaged or worn parts that can adversely affect stability and handling, which could result in death or serious injury. Pull down the top of the door to open. Keep the radiator screen and outlet duct clean and free from obstructions. Using liquid tire balancers or sealants can cause rapid corrosion of the rim surface, which could cause tire deflation. Do not operate catalytic converterequipped vehicle with engine misfire. Hex plug do not remove Oil Pan 1.
With the engine running and the jiffy stand retracted, pull the clutch hand lever in against the handlebar grip to fully disengage the clutch. Manual suspension models: See Manual Suspension Preload Adjustment. See Engine Oil Filler Plug. Avoid loose, flowing garments and scarves. Upshift Acceleration See Shifting Sequence: Upshift. Partially open the throttle so the engine does not drag when the clutch lever is released.