Please take the time to get well acquainted with your vehicle by reading this handbook. Detailed satellite instructions are included with the dealer installed kit. The following table tells you which transmission or transaxle each code represents. Press the right side to restore the window controls. See your Ford or Lincoln Mercury dealer. Switch off the engine and allow it to cool.
Open the liftgate, then locate the access panel on the floor behind the 3rd row seat. Using a step bumper The rear bumper is equipped with an intregal hitch and requires only a ball with a 1 inch shank. In a collision, people riding in these areas are more likely to be seriously injured or killed. Turn the engine off and wait a few minutes for the oil to drain into the oil pan. Here are some general precautions for your safety: Do not work on a hot engine.
For proper latching, ensure that the floor tubs are clear of debris. Set the parking brake and ensure the gearshift is securely latched in P Park. However, if fluid is added at this time, an overfill condition could result when the vehicle reaches normal operating temperature. See Attaching safety seats with tether straps in this chapter. If you must drive with the liftgate open, keep the vents open so outside air comes into the vehicle. Transmission operates in gears one through four.
Do not allow people to ride in any area of your vehicle that is not equipped with seats and safety belts. Determine which time zone you are in by referring to the zone map. The compass is now calibrated. If other than Ford, Motorcraft or Ford-authorized parts are used for maintenance replacements or for service of components affecting emission control, such non-Ford parts should be equivalent to genuine Ford Motor Company parts in performance and durability. A garage door which cannot detect an object, signaling the door to stop and reverse, does not meet current U.
Attach the new wiper to the wiper arm and press it into place until a click is heard. Repeat this procedure for another remote transmitter if desired. Press the mode control to display the instantaneous fuel economy of your running vehicle. . If a transmitter is lost, a new one may be programmed by your dealer. If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount.
The kit to enable the Satellite reception is available through your Ford dealer. Refer to the scheduled maintenance guide for the service interval schedules. Disconnect the bulb assembly from the lens. See Engine oil in the Maintenance and Specifications chapter for more information on oil usage. Refer to Compass zone adjustment in this section. Remove and replace the bulb. Turn off the air suspension switch.
Grasp the tether strap and position it to the seat frame. Within 15 seconds, insert a new key into the ignition and turn the ignition to On or Start. This action could damage the power steering pump. Pull the lever towards you to deactivate. Refer to Control trac system in the Driving chapter for more information.
The oil from your hand could cause the bulb to break the next time the headlamps are operated. For your safety and to maximize vehicle performance, be sure to use the proper equipment while towing. Lay the tire on the ground, near the rear of the vehicle, with the valve stem side facing up. Grasp the bulb only by its base. I … purchased my kit over a year ago from here and love the ride! Locate compass sensor mounted at base of mirror. Underneath the vehicle front and the rear.